The BP-1W Booster/Preamp takes the analog preamp stages from two vintage units, the Boss CE-1 Chorus Ensemble and the Roland RE-201 Space Echo, and puts them in a Waza Craft compact with no chorus or echo attached. Players have long run those machines for the preamp colour alone, and this is that part on its own.
A mode switch picks the voice. CE recreates the CE-1 preamp, which Boss describes as bright and ringing with a tight low end. RE recreates the RE-201's, thicker and warmer even at low Gain, compressing and saturating as you turn it up. NAT is a clean boost with very little colour. Gain sets the saturation for each mode and Level sets the output, enough to push an amp's input or the next pedal.
A rear switch chooses between a standard buffer and a vintage buffer with a lower input impedance that Boss says sounds warmer, with the most effect when a passive guitar plugs straight in. In bypass the standard buffer stays on. It works as an always-on tone shaper at the front of a board, or as a boost into an amp that's already breaking up.
SPECIFICATIONS
CONTROLS
Controls: GAIN knob, LEVEL knob, BUFFER switch (STD/VTG SW), MODE switch, Pedal switch
Indicator: CHECK indicator (Serves also as battery check indicator)
CONNECTIONS
Connectors: INPUT jack: 1/4-inch phone type, OUTPUT jack: 1/4-inch phone type, DC IN jack
SPECS
Nominal Input Level: -20 dBu
Input Impedance: Effect OFF: 1 M ohms / Effect ON: 1 M ohms (BUFFER switch: STD), 100 k ohms (BUFFER switch: VTG)
Nominal Output Level: -20 dBu
Output Impedance: 1 kΩ
Recommended Load Impedance: 10 kΩ or greater
Bypass: Buffered bypass
POWER
Power Supply: Alkaline battery (9 V, 6LR61), AC adaptor (PSA series: sold separately)
Current Draw: 60 mA
Expected battery life under continuous use: Alkaline: Approx. 4.5 hours
DIMENSIONS
Width: 73 mm / 2-7/8 inches
Depth: 129 mm / 5-1/8 inches
Height: 59 mm / 2-3/8 inches
Weight (including battery): 430 g / 1 lb



