The DD-8 is Boss's most fully loaded compact delay: eleven modes, up to 10 seconds of delay with tap tempo, and full stereo in a standard Boss housing. The modes run from Standard, Analog and Tape through Warm, Reverse, Shimmer and Mod, plus +RV (delay with reverb), Warp for held-switch swells and GLT for glitchy, rhythmic repeats. The eleventh is a looper with up to 40 seconds in mono and unlimited overdubs.
Stereo I/O comes with three output modes: independent, panning for ping-pong, and wide. The jacks configure themselves by how they're cabled, so it runs mono, stereo, wet/dry or wet-only for a parallel loop. A Carryover switch decides whether trails ring out on bypass. Add one or two footswitches for tap tempo, looper control and the Twist effect, or an expression pedal for level, feedback and time.
For the same idea with stored presets, MIDI and a larger panel, look at the DD-200; the DD-3T keeps it to three time ranges with a direct out.
SPECIFICATIONS
CONTROLS
Controls: MODE knob; TIME knob; FEEDBACK knob; E.LEVEL (Effect Level) knob; CARRYOVER switch; Pedal switch
Indicator: CHECK indicator (Used for indication of check battery)
CONNECTIONS
INPUT-A (MONO)/INPUT-B jack: 1/4-inch phone type
OUTPUT-A (MONO)/OUTPUT-B jack: 1/4-inch phone type
TEMPO/EXP jack: TRS 1/4-inch phone type
DC IN jack
SPECS
Nominal Input Level: -20 dBu
Input Impedance: 1 M ohm
Nominal Output Level: -20 dBu
Output Impedance: 1 k ohm
Recommended Load Impedance: 10 k ohms or greater
Bypass: Buffered bypass
POWER
Power Supply: Alkaline battery (9 V, 6LR61); AC adaptor (PSA series: sold separately)
Current Draw: 100 mA
Expected battery life under continuous use: Alkaline: Approx. 3.5 hours
DIMENSIONS
Width: 73 mm / 2-7/8 inches
Depth: 129 mm / 5-1/8 inches
Height: 59 mm / 2-3/8 inches
Weight (including battery): 440 g / 1 lb



