The Signal Filter is a bass pedal with two variable filters: a High Pass that sweeps from 38Hz to 310Hz and a Low Pass that sweeps from 15kHz down to 330Hz, each cutting at a steep 24dB per octave. Instead of boosting or cutting a band the way an EQ does, it sets where your sound starts and stops, and leaves everything in between untouched.
Raise the High Pass to tighten a boomy low end on stage, or lower the Low Pass to warm up a bright or clanky top. A Hi Pass Gain control adds up to 15dB to make up any level lost when you trim the deep lows, and the two filters switch in independently. The sweep ranges match the filter section on the Bullhead 1.5K and 3K heads, so you can bring that control to any amp.
It is one of four compact Trickfish pedals that each do a single job, alongside the External Preamp, the Overdrive Preamp and the VCA Compressor. All four share the same steel housing and 9V supply.
SPECIFICATIONS
SPECS
High Pass Filter: 24dB/octave, sweep from 38Hz to 310Hz
Low Pass Filter: 24dB/octave, sweep from 330Hz to 15kHz
Hi Pass Gain: 15dB of gain for hi pass filter
Input/Output Impedance: 1M Ohm / 100k Ohm
Power Requirements: 9V DC (center pin negative)
Power Consumption: 7 mA
Chassis: Steel, removable adhesive-backed rubber feet
Size including knobs (H x W x L): 2.29 (top) 1.96 (bottom) x 2.72 x 5.08 in / 58.2 (top) 49.9 (bottom) x 69 x 129.7 mm
Weight: 0.98 lbs / 0.45 kg
CONTROLS
HI PASS FILTER: frequency
LO PASS FILTER: frequency
HI PASS GAIN
HP+GAIN: footswitch, toggles effect on/bypass
LO PASS: switches the Low Pass filter in, independently selectable
CONNECTIONS
IN: 1/4" phone jack input
OUT: 1/4" phone jack output
DC IN: 9V DC, center pin negative



